In this article
In rural areas, a power outage often cuts water along with the lights: the well pump is electric. Taps, toilets and showers stop, and when power returns the pump may refuse to restart. Understanding your system and preparing a few solutions saves a lot of trouble, especially in winter.
In short
In short. Identify now your pump type (submersible, jet, hand), its breaker and the pressure tank. Keep at least a 72-hour water supply. To run the pump during an outage, you need a generator properly connected by an electrician, or a hand pump installed in advance. After the outage, a jet pump may need to be re-primed: follow the manufacturer’s manual.
Know your pump
| Type | Location | During an outage |
|---|---|---|
| Submersible pump | At the bottom of the well, often deep | Stops completely; often needs 240 V and a generator with enough power |
| Jet pump | In the house or a shed, for shallow or medium wells | Stops; may lose its prime and need re-priming |
| Hand pump | On the wellhead | Works without electricity, depending on depth and model |
The pressure tank keeps a few litres available at the start of an outage: use them for essentials.
Before the outage
- Note the pump model, voltage and power (on the label or in the manual).
- Locate the pump breaker and the pressure switch.
- Keep bottled water for drinking and water containers for washing and flushing.
- Fill the bathtub and buckets as soon as a storm is forecast.
Powering the pump with a generator
The pump draws a lot at start-up: the generator must handle that surge. The connection to the house must go through a transfer switch or interlock installed by a master electrician: an improvised hookup can backfeed the grid and electrocute a line worker. See our generator guide, and never run it indoors.
The hand pump, a self-reliance option
A hand pump installed on the well lets you draw water without electricity. The choice depends on the depth of the water level and the casing diameter; installation must comply with well regulations and be done by a professional if it involves the well cap or casing. See our hand pump comparison and the ways to get well water without power.
When power returns
- Check that the pump breaker is on.
- Open a tap and watch: water should return within seconds or minutes.
- If a jet pump runs without delivering water, shut it off: it has probably lost its prime. Re-prime it following the manufacturer’s manual (filling the pump body through the priming plug), then restart it.
- If the pump will not start or the problem persists, call a well contractor or an electrician.
In winter
A long outage in extreme cold can freeze the jet pump, pipes and tank. Keep the room above freezing if possible, and drain the plumbing as your installer instructs if the house must stay cold for a long time.
Water quality
After a flood, well water can be contaminated. Follow official guidance: do not drink it until it has been tested, disinfect the well if needed and boil water in the meantime.
Key points
- KnowPump type, voltage, breaker, tank.
- PlanWater supply, generator connected by an electrician, or a hand pump.
- RestartRe-prime a jet pump following the manual.
Frequently asked questions
Can a home battery run the pump?
Some battery storage systems can, if they handle the start-up surge. Have the system sized by a professional.
Is the water in the tank drinkable?
It comes from the same well: if the well water is normally safe to drink, so is the tank water.
Safety. Any electrical work on the pump or generator connection must be done by a master electrician. For water quality, follow official guidance and have your water tested.
Sources
- Government of Quebec (Québec.ca), private wells: maintenance, testing and disinfection.
- Hydro-Québec, safe generator use.
- Pump manufacturers’ manuals.
Go further: the Power outage fact sheet.

